CEMIX Adeblok Plus

Home : PRODUCTS : Stuccos : CEMIX Adeblok Plus

CEMIX Adeblok Plus is a mixture of cement, select aggregates, powder resins, fibers, and chemical additives that when mixed with water forms an easily workable paste. A great variety of finishes and textures can be obtained by using Cemix Adeblok Plus in both interiors and exteriors.

Uses and advantages

Special formula prevents water filtration to the interior since this an impermeable (waterproofing) product.
Reduces application times compared to plastering, lathing and finishing methods.
Quick and easy application.
Improves inventory control.
Can be applied manually or mechanically.
Factory premeasured.
Contains polypropylene fibers that reduce surface cracking.
Low maintenance.
Does not require specialized labor.

Technical Information

Property	Description	Standard
Product density in powder form	3628 lb/1.3 yd³ (1649 kg/m³)
Density of hardened product	5317 lb/1.3 yd³ (2417 kg/m³)
Percentage of water in mixture	20%
pH of product mixed with water	> 12
Water retention percentage	> 90%	ASTM C-887
Curing Time vicat	Initial...< 12 hours
	Final... 24 horas
Minimum resistance to compression at 28 days	100 kg/cm²	ASTM C-109
Granulometric Analysis	100% < mesh 16
Ash Percentage at 850°F (450°C)	> 1%
Ash Percentage at 1650°F (900°C)	> 50%
Water Absorption Percentage	.5%-1%

Presentation

88 lb (40 K) bag

Approximate coverage

For smoothing (one coat): covers at a rate of 13.2 to 22 lbs per 10.8 sq ft (6 to 10 kg/m2) using a 1/8” to 1/4” (.4 cm to .6 cm) thickness.
For smoothing and texturizing (two coats): covers at a rate of 19.8 to 28.6 lbs per sq ft (9 to 13 kg/m2) using a 3/16” to 3/8” (.5 cm to .8 cm) thickness.

NOTE: Coverage is approximate and for estimation purposes only. Coverage will vary depending on the substrate conditions and the method of application.

Recommendations

For optimal results, do not apply CEMIX Adeblok Plus when the temperature is expected to drop below 40°F (4°C) or above 113°F (45°C) during the following 24 hours after application or if there is a probability of rain.
Do not add more water after preparing the mixture since this decreases the product’s final hardness and results in white stains that are lighter than the rest of the applied product.